Macro
Read More
Five components on a printed circuit board. The tan colored components are capacitors and the black component is a resistor. Each component is roughly 1mm x 0.5mm. This board was run as a test to evaluate the quality of solder joints on these components (thus none of the surrounding components are placed).
Lighting setup is a SB-600 triggered remotely shooting through sheet of copier paper.
Detail of pads (the two pads just above and left of center) that have had solder mask removed via a laser process. Pads are approximately 0.6mm x 0.5mm.
Lighting setup is a SB-600 triggered remotely shooting through sheet of copier paper.
Detail of pads (the two pads just below center) that have had solder mask removed via a laser process. Pads are approximately 0.6mm x 0.5mm.
Lighting setup consisted of placing the board inside a small collapsable light tent which was then lit with a remotely fired SB-600.
